2004 Chevrolet Impala
Mileage
221,893
Service Date
8/22/2025
Services Performed
- Tech inspected and determined that vehicle was in need of the rack opinion and the complete sway bar assembly and both outer tie rods and the driver side front CV axle and the front driver side hub assembly and an alignment.
- STEERING GEAR (COMPLETE) – Remove & Replace – 3.8L Eng – [Includes: Adjust toe-in.] – [Includes: Manual and Power Rack & Pinion, Worm & Ball Nut and Rack & Piston Assemblies. Adjust Toe-in on Rack & Pinion models. DOES NOT include transfer of components o
- WHEEL HUB – Remove & Replace – Front,One Side – [Includes: Replace Inner and/or Outer Bearings, Cups, Seals and repack (where applicable).]
- STABILIZER BAR – Remove & Replace
- STABILIZER BAR CONTROL LINK – Remove & Replace – Both
- TIE ROD &/OR END – Remove & Replace – Outer,Both – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models. If
- Place vehicle on alignment rack, attach equipment, measure caster, camber and toe. Compare to vehicle specifications. Set and adjust all approved alignment angles with allowable specifications.
- AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Driver Side – [NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
Mike B. gave our service a 5 star review on 8/23/2025
