DISC ROTOR – Remove & Replace – Gas Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
Steven M. gave our service a 5 star review on 11/16/2022
2013 Toyota Avalon CRM Mitchell1
2022-11-18T22:59:36+00:00
There was a nut loose, so we tightened it and it's working properly now.
We heard a clatter for the first few seconds when starting the car, pulled it in and it did stall when we stopped abruptly. Technician checked the oil level and there was no oil on the dipstick. We recommended doing an oil change and monitoring the oil level every time filling up the fuel so we can monitor the amount of oil that's being used.
Drain and fill engine oil and remove and replace oil filter. Top off all fluids, check battery, lights, belts and hoses.
Colleen J. gave our service a 5 star review on 10/13/2022
2011 Toyota Camry CRM Mitchell1
2022-10-14T22:00:13+00:00
The light was actually a maintenance light because oil change was due. We reset the light when we did the oil chane.
No bearing noise was heard.
Drain and fill engine oil and remove & replace oil filter. Top off all fluids, check battery, lights, belts and hoses.
DISC ROTOR – Remove & Replace – Gas Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
DISC ROTOR – Remove & Replace – Gas Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Gas Left Side – [DOES NOT include alignment. NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
Rob C. gave our service a 5 star review on 11/18/2021
2016 Toyota Camry CRM Mitchell1
2021-11-20T23:01:09+00:00