There was a cylinder #1 misfire. The tech checked the spark plugs and they were worn. Tech swapped the cylinder #1 ignition coil with cylinder #2 and the cylinder 1 plug with cylinder #3 plug. The misfire moved to cylinder #1, indicating a bad ignition coil. The air filter was dirty. We recommended a tune-up, including spark plugs, ignition coils and air filter. P0301 P0625
ELECTRONIC IGNITION (MINOR) – Tune – [Includes: Check compression. Clean or replace Air Cleaner Element and Spark Plugs. Inspect or replace Coil Boots or Ignition Cables.]
Roger G. gave our service a 5 star review on 10/3/2025
Technician took the vehicle for a test drive and then inspected the vehicle. The rear brake pads were down to 3 mm, the rear brake rotors were warped. The front brake pads had material left but the rotors were warped. We recommended replacing the front and rear brake pads and rotors.
DISC ROTOR – Remove & Replace – Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
DISC ROTOR – Remove & Replace – Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
Tire rotation
Traci D. gave our service a 5 star review on 9/27/2024
Drain and fill engine oil and remove & replace oil filter. Top off all fluids, check battery, lights, belts and hoses.
There was no freon in the AC system. Advised customer to start with recharging the system with dye. Advised customer if the air starts blowing warm again, to bring the vehicle back right away and we will be able to detect the leak with the dye.
The serpentine belt and tensioner needed to be replaced.
Technician inspected and found the rear brake pads and rotors are down to 2 mm and need to be replaced. The rear shocks were leaking oil and needed to be replaced.
DISC ROTOR – Remove & Replace – Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace -rear Both – [DOES NOT include disassemble or alignment.]
DRIVE BELT TENSIONER – Remove & Replace – In-Line4 – [Includes: Replace Belt (if necessary).]
AIR CONDITIONING SYSTEM – Complete Charge – [Includes: Air Conditioning system recover, evacuate and recharge.]
LOW PRESSURE CUT-OFF SWITCH – Remove & Replace
Abel F. gave our service a 5 star review on 5/6/2024